I've been reading a few posts on different forums suggesting that background encoding on SP2 is not adviseable and that one should encode eveything prior to import into SP2 with Compressor. I actually tried this on my first project and kept getting encode errors. When I used the background encoding (same settings) - no errors and eveything seemed fine. One problem that is a part of all this is that if Iexport movies from an Avid (using Avid codec) I end up with very 'milky' blacks when I burn the DVD. I'm working in PAL. Any comments or solutions.

Add To Archive

email this post

CURRENT THREAD: Read whole thread

• background encoding by Peter Hickson at May 07, 2004 5:21 am gmt (Rec'd 12)
  • Re: background encoding by David Nagel at May 08, 2004 5:52 pm gmt (Rec'd 2)
    • Re: background encoding by Peter Hickson at May 10, 2004 4:23 am gmt (Rec'd 1)
      • Re: background encoding by Peter Hickson at May 11, 2004 12:13 am gmt (Rec'd 2)

Next Post: Can a button remember? by Mark Griesbauer at May 07, 2004 2:11 pm gmt

Previous Post: iDVD by Ko at May 07, 2004 4:19 am gmt

Check if you would like to receive notice when your post has been responded to.
Note: This requires your email address to be correctly filled in. Your email address will not be displayed on the posts.

The Subject of Your Post:

Your Post's Message:

Please click one time only

Return to Posts Index

Top